You are here:Home >> Products >> RF DIM Controll... >> LED Controller

Products

Products

COB LED strip
Strip Flex
Special LED Strip
Neon Flex
IC Built in LED Strip
LED linear Light
Silicon flex tube
LED Profile
Accessory

Contact us

RF DIM Controller

RF DIM CC Controller

 
     

    Feature

    ● One RF dimmer accept up to 10 remote control.
    ● Auto-transmitting function: Receiver could transmit signal to another receiver within 30m,
    and the total remote control distance can up to 100m.
    ● Connect with external push switch to achieve on/off and dimming function.
    ● Match with all easinghome 2.4G dimming remote control.

    Technical parameter


    Dimension

    Match remote control (two match ways)

    ● Use the controller’s Match key

    Match:
    Short press match key, immediately press on/off key(single zone remote)
    or zone key(multiple zone remote) of the remote.
    Delete:
    Long press match key for 5s, delete all matched remote.

    ● Use Power-up

    Match:
    Switch off the power, then switch on power again, immediately short press on/off key
    (single zone remote) or zone key(multiple zone remote) 3 times on the remote.
    The light blinks 3 times means match is successful.

    Delete:
    Switch off the power, then switch on power again, immediately short press on/off key
    (single zone remote) or zone key(multiple zone remote) 5 times on the remote.
    The light blinks 5 times means delete all matched remote.

    Push Dim

    When use Push Switch, click push switch for switch ON/OFF, hold push switch for dim the brightness.
    Wiring diagram


    1.The controller could auto check and output a proper voltage according to its LED quantities.
    2.The controller works on buck mode, the voltage of power supply should be greater than
    the total voltage of the seried LEDs.

    Malfunctions analysis & troubleshooting


    Safety information

    1. The product shall be installed and serviced by a qualified person.
    2. The product is non-waterproof. Please avoid the sun and rain.
    3. Good heat dissipation will prolong the working life of the controller. Please ensure good ventilation.
    4. Please check if the output voltage of any power supplies used comply with the working voltage of the product.
    5. Ensure all wire connections and polarities are correct and secure before applying power to avoid any damages
    to the LED lights.
    6. If a fault occurs please return the product to your supplier. Do not attempt to fix this product by yourself
    File Name : Format: Size: Download:
    Please submit your basic information, we will contact you as soon as possible!

    *

    *

    *

    *

Related products